Gaggia short camme

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Gaggia italia gasket and shim set. This set contains 4 inox shims and 4 v piston seals

Gaggia piston gasket

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

The product on this page is a stainless steel piston for the Gaggia America and Gaggia Italia lever brewing groups. This piston has been made from 1 piece of stainless steel. The outer diameter of the piston is 50mm and the length is 82mm. The piston has the one way valve already installed. The piston also comes with a stainless steel shower screen with a...

Gaggia piston boltReturn to the Gaggia Italia group overview

Gaggia steel ballReturn to the Gaggia Italia group overview

The compression spring on this page can be used in various Lever espresso machines. But to start: Always check the dimensions of your original spring. The product on this page has a overall length of 169mm and a outer diameter of 46mm. The compression spring is made from spring steel and has been galvanized. This compression spring can be used on a...