Gaggia italia gasket and shim set

Gaggia filterholder gasket 73,5x57,5x8,5mmReturn to the Gaggia Italia lever group parts overview

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Gaggia steel ballReturn to the Gaggia Italia group overview

Safety valve 1/2"1,8 Certif CE PED IV

Gaggia group locking gasket FDA gradedReturn to the Gaggia Italia group overview

Gaggia group shower dia 49mm

This item is the nut installed on the top of the piston shaft on various Gaggia lever espresso machines. With this you can fixate the bottom nut. This item is unfortunately out of production and won’t be made anymore.

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.