Gaggia group locking gasket

The compression spring on this page can be used in various Lever espresso machines. But to start: Always check the dimensions of your original spring. The product on this page has a overall length of 169mm and a outer diameter of 46mm. The compression spring is made from spring steel and has been galvanized. This compression spring can be used on a...

The item on this page is a Gaggia lever group piston shaft. This item is made up out of a gear rack and the bottom coupler. This coupler can be easily disconnected from the piston shaft itself. This coupler can be attached to the stainless steel piston. This item is unfortunately out of production and not available anymore.

Safety valve 1/2"1,8 Certif CE PED IV

Gaggia piston gasket

Gaggia portafilter supplement

This cam guide is vital in the lever mechanism used on the old Gaggia lever brewing groups. This cam guide is installed inside the side of the brewing group. The  lever cams do slide over this shaft. This item is not in production anymore.

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

The single filterbasket on this page can be used on a variety of Gaggia espresso machines. This filter basket is manufactured by the Italian company IMS filtri with the reference of GA1T182. This 1 coffee filterbasket can hold about 7 grams of ground coffee. The outer diameter of this filter basket is 68mm and the height is 24,5mm. The hole pattern is in...