Gaggia portafilter supplement

The compression spring on this page can be used in various Lever espresso machines. But to start: Always check the dimensions of your original spring. The product on this page has a overall length of 169mm and a outer diameter of 46mm. The compression spring is made from spring steel and has been galvanized. This compression spring can be used on a...

Gaggia filterholder gasket 73,5x57,5x8,5mmReturn to the Gaggia Italia lever group parts overview

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Gaggia short cammeReturn to the Gaggia Italia lever group parts overview

Gaggia italia gasket and shim set. This set contains 4 inox shims and 4 v piston seals

Safety valve 1/2"1,8 Certif CE PED IV

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

Gaggia steel ballReturn to the Gaggia Italia group overview