Looking for similar items or different specifications for this La San Marco PTFE HX gasket 34x27x2mm? Explore our full range in the La San Marco 85 leva group category
Details
12-175-N-700418/T
12 Items
Data sheet
Brand
La San Marco
Gasket Material
PTFE
Type part
Group locking gasket
Review
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
When you replace gaskets in your espresso machine it might be handy that you use some kind of lubricant to lubricate your o rings or rubber like gaskets. But you don’t replace gaskets that often, then the need for a big tube of silicone grease is not a necessity. In this case we have a small, closable, tube of silicone grease. This tube contains 6 grams...
On this page you will find a safety valve which has a male 3/8”BSP-G thread. The pre-set pressure of this valve is 1,8bar. You can adjust it yourself but not recommended. The spring inside the safety valve is made from stainless steel and the sealing material is FKM. The valve has been made in Italy. We do strongly advise to replace the safety valve every...
The element shown on this product page can be ideal to make from your 220/230V Faema E61 a 110V model. This heating element has the typical Faema type of brass flange. The element is powered at 110V and supplies 2600W. The immersed length of the element is just 350mm. The heating element gasket used for this element has a outer diameter of 57mm a inner...
Faema E61 plastic cup warmer knob. This knob is used on 2 locations on the Faema E61. The first location is on the regeneration valve. The second location is on the valve to controle the cup warmer ring. this ring is missing on most machines, but you can't miss the valve on a e61!