- Vintage lever Espresso Machines
- Faema E61 espresso machine
- Brands
- Accessories
- Spares
- Blog
- Custom gaskets
Bob
Gaggia C70 C80 piston gasket
€2.99
€2.99 tax excl.
GDPR Compliance
Protecting your personal data
Shipping policy
Everything about shipping your order
Return policy
all the inns and outs about our return policy
the piston gaskets on this page are used on various older Gaggia espresso machine models. These piston gaskets can be used on the Gaggia C70/C80 lever brewing groups. The piston gaskets are there for to seal off the piston and the piston walls during the operation.
These piston gaskets are made from NBR.
50-061-L-5167905
32 Items
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
Your review cannot be sent
8 other product
Gaggia rubber ring
This rubber o ring is used on the Gaggia brewing groups C70/C80 and is used on the flange side of the brewing group. This o ring is made from EPDM and has a cord diameter of 1,78mm and a internal diameter of 25,12mm. This o ring is made in Italy.
Bob
€1.37
Gaggia ball bearing
The bearing is essential on a lever espresso machine brewing group. Otherwise it is not possible to transfer the lever movement in a vertical movement. In the brewing group of the Gaggia lever groups the bearings are embedded inside the group. On each side you will find one bearing where the pinion gear can ride on.
Bob
€8.87
Gaggia inlet pipe
This item is a brewing group water inlet tube which is used on various Gaggia C70/C80 brewing groups. This brewing group inlet tube is made from a copper tube which has been bend and flared at the ends. You do need to use this copper tube in combination with a nut. This item has limited availability.
Bob
€11.12
Gaggia top nut
This item is the nut installed on the top of the piston shaft on various Gaggia lever espresso machines. With this you can fixate the bottom nut. This item is unfortunately out of production and won’t be made anymore.
Bob
€6.29
Lever group shower 57mm
A lever brewing group uses slightly different parts then a normal pump driven espresso machine. This is the same story for the shower screens used. This shower screen made by the Italian company IMS Filtri is a example of this. This shower screen clamps around the sleeve of the brewing group to keep it into place. The outer diameter of this shower screen...
Bob
€9.19
Gaggia lever group pinion gear
It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...
Bob
€72.55