Faema E61 legend 1 group heating element original

Faema E61 expansion valve 3/8" BSP-G. This complete valve is made in the same style as the original expansion valve. The valve consists of the following components:Faema E61 Expansion Valve Nipple; Faema E61 Expansion Valve Guide; Faema E61 Expansion Valve Gasket; Faema E61 Expansion Valve SpringReturn to the Faema E61 valve parts overview

This tamper is made from Stainless steel EN 1.4301/AISI 304 with a smooth machined finish. The bases are laser engraved with our logo and the 58 mm diameter of the base of the tamper. All our tampers are made in The Netherlands The handle is made from birch which has been hand oiled 2 times. Try to avoid contact with water. Seen the handles are natural...

Faema E61 stainless steel gigleur spring. if your replacing this part don't forget to replace the rest of the sealing parts of the group. We offer a handy rebuilding kit for that. (the gigleur spring is also in that kit) Return to the Faema E61 group parts overview

The sight glass on this page can be used on various Vibiemme espresso machine models. The Vibiemme part reference for this item is MATECVELI140  This sight glass has a outer diameter of 11mm and a overall length of 140mm. this sight glass has silk printing on the glass. There is on the back a red line and on the front the lettering of max and min. This...

The item on this product page is a OEM/Original Bezzera nipple/shaft holder. This unit is used in various espresso machine models of Bezzera. The Bezzera part reference number is 5223402.  This steam and water valve nipple/shaft holder is made from machined brass. The item is made in Italy. You can use this brass fitting on the Bezzera B2000, Bezzera...

La Cimbali heat exchanger (HX) has a total length of 210mm and a outside diameter of the tube of 42mm.This part is sticks inside the boiler. And it is held in it's place from the boiler side, with a La Cimbali HX ring, then the HX and inbetween the La Cimbali HX and the brewing group there is a o ring to seal it off.Return to the La Cimbali M20 parts...

On each side of the aluminium casting used on the Faema Lambro, Faema President and the Faema Urania you will a pressed bracket. These brackets guide the bearings over the flattened-out surface on this bracket. The article listed on this page is for the right side of the group. To be sure that you order the correct side. The rounded where the rounded off...

La San Marco lever lower valve cap. this cap holds the group gasket holder spring in place.Return to the  San Marco group parts overview