Vibiemme Domobar Junior 2B boiler

On this page you will find a certified boiler safety valve, it has CE-PED. This boiler safety valve is one of the most common types around. This valve is pre-set at 2,0 bar and can’t be changed. On the inside of the valve is a FKM gasket, the spring installed is made from stainless steel. The steam discharge rate when opened is 969 L/min. This valve has...

Vibiemme heating element 1200V 230V Type Thread 1"watt 1200volt 230length (mm) 100

Anti vacuum valve TV 1/4". Suitable for:CodeProducerA10220 Astra000634 Aurora-brugnetti7452502 Bezzera05062.4.00.09 Brasilia01.00504 Carimali418-911-002 Cimbali418-911-010 Cimbali418911010 Cimbali408898 ContiC219900560 Ecm00200034 Elektra65000205 Expobar2161-118968 Faema2161118968 Faema418911002 Faema...

Gicar level regulator RL30/1E/2C/F 115V

Heating element gasket PTFE 52,2x41,2x1mm

Vibiemme manometer 0 - 16 bar with capillary

This contact thermostat has a shut off temperature at 165 °celcius. In this case it is a manual espresso machine thermostat. That means that it needs to be pushed manually to reset.  With a automatic one it will reset itself. On the bottom of this thermostat is a M4 male screw thread. You can screw the thermostat into a boiler for instance. For a brewing...

On this product page you can find a XP110 pressure switch suitable for the Elektra Microcasa a Leva and the Isomac models Mondiale, Millennium and Tea. The part references for Elektra are01344035. This pressure switch has been manufactured by the company Ma-Ter. The maximum capacity is 15A at 125/250Vac. The maximum working temperature is 125 degree...

If you are converting your Faema e61 with a new boiler, it can be practical to order this boiler fitting at the same time. As you can see, the new boiler does not come with this fitting. This fitting, cast and machined from brass, has a ½ ”BSP-G male thread on 2 sides. And on one side a ¼ ”BSP-G female thread. So screw it into the bottom of the HX on one...

If you are rebuilding your Faema e61 with a new boiler it might be handy to order this boiler fitting along with it. Seen the new boiler isn’t supplied with this fitting. This brass casted and machined fitting has on 2 sides a male ½”BSP-G thread. So to screw it on one side in the HX on the boiler and for the other side to the brewing group. This item has...

Vibiemme boiler manometer 0 - 4. Fitting 1/8" M

On this page you will find a 2 way solenoid valve manufactured by the company Parker, this specific valve has been produced in Italy. This solenoid valve is mainly used as a water inlet valve and a steam and water valve solenoid. The Parker part numbers for this item are 397442 and 397443. This solenoid valve is a version which has a female threaded in...