Adria Argenta Brava CK CKE CKX CKXE Calypso Denise Divina Dora Gloria Lisa Perla Plus 4 You Pratic Pratic new Rapallo Rapallo AL Sabrina Sibilla Tanya Vania
On this page you will find a rubber back stop used with a variety of and newer lever espresso machine brewing groups. You will find this back stop on Astoria and Wega models pre 2001. Currently you can find them on brewing groups used by Bezzera 5473001 , Pavoni 477020, Victoria Arduino 17000018, Wega WY15101 and Brasilia 01431.0.00.02. For Pavoni groups,...
Pressure switch bracket made out of stainless steel 304. The bracket has a length of 90mm and a width of 18mm. This bracket is intended to fix one side to a boiler stud or inbetween a boiler bolt (up to M10).The other side is suitable to fit a pressure switch with a 1/4" BSP-G connector.
This tamper is made from Stainless steel EN 1.4301/AISI 304 with a smooth machined finish. The bases are laser engraved with our logo and the 50 mm diameter of the base of the tamper. All our tampers are made in The Netherlands The handle is made from American walnut which has been hand oiled 2 times. Try to avoid contact with water. Seen the handles are...
This specific type of switch is used for the La Pavoni Romantica, La Pavoni Europiccola for the configurations ERG, ELH, EL and EN. The part number for the La Pavoni is 435063.But this model of switch is also used on the Gaggia Factory 105 (S435063) This specific model red bipolar switch is a rocker switch with a pilot light. The mounting hole for this...
This boiler pressure gauge can be found from one of the earliest Faema E61 espresso machines as well for the Faema President lever espresso machines. This pressure manometer has a pressure reach of 0 to 3 bar. The body diameter is 52mm the rim has a diameter of 71mm. At the back is a fitting which is a male 1/8”BSP-G thread. The manometer has been...