Gaggian tuloputki

Vipun panimoryhmä käyttää hieman eri osia, sitten normaali pumpun ajama espressokone. Tämä on sama juttu käytettyjen suihkujen kohdalla. Tämä italialaisen IMS Filtri -yhtiön tekemä suihkuruutu on tästä esimerkki. Tämä suihkunäytös kietoutuu panimoryhmän hihnan ympäri pitääkseen sen paikoillaan. Tämän suihkunäytön ulompi halkaisija on 57 mm Tämä suihku on...

This rubber o ring is used on the Gaggia brewing groups C70/C80 and is used on the flange side of the brewing group. This o ring is made from EPDM and has a cord diameter of 1,78mm and a internal diameter of 25,12mm. This o ring is made in Italy.

Safety valve 1/2"1,8 Certif CE PED IV

This compression spring is vital in the lever mechanism used on the old Gaggia lever brewing groups. This spring is installed inside the side of the brewing group, with a small ball bearing on top of it. If this item is missing in your brewing group your brewing group mechanism won’t function properly. This compression spring is unfortunately out of...

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Gaggia steel ballReturn to the Gaggia Italia group overview

The item on this page is a Gaggia lever brewing group spring guide, this item can be found on the Gaggia C70/C80 brewing groups. The spring guide, keeps the main compression spring centred, has been made from pressed copper. Limited stock available

the piston gaskets on this page are used on various older Gaggia espresso machine models. These piston gaskets can be used on the Gaggia C70/C80 lever brewing groups. The piston gaskets are there for to seal off the piston and the piston walls during the operation. These piston gaskets are made from NBR.