Gaggia kumirengas

This item is the nut installed on the top of the piston shaft on various Gaggia lever espresso machines. With this you can fixate the bottom nut. This item is unfortunately out of production and won’t be made anymore.

Gaggia steel ballReturn to the Gaggia Italia group overview

This cam guide is vital in the lever mechanism used on the old Gaggia lever brewing groups. This cam guide is installed inside the side of the brewing group. The  lever cams do slide over this shaft. This item is not in production anymore.

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Vipun panimoryhmä käyttää hieman eri osia, sitten normaali pumpun ajama espressokone. Tämä on sama juttu käytettyjen suihkujen kohdalla. Tämä italialaisen IMS Filtri -yhtiön tekemä suihkuruutu on tästä esimerkki. Tämä suihkunäytös kietoutuu panimoryhmän hihnan ympäri pitääkseen sen paikoillaan. Tämän suihkunäytön ulompi halkaisija on 57 mm Tämä suihku on...

the piston gaskets on this page are used on various older Gaggia espresso machine models. These piston gaskets can be used on the Gaggia C70/C80 lever brewing groups. The piston gaskets are there for to seal off the piston and the piston walls during the operation. These piston gaskets are made from NBR.

This compression spring is vital in the lever mechanism used on the old Gaggia lever brewing groups. This spring is installed inside the side of the brewing group, with a small ball bearing on top of it. If this item is missing in your brewing group your brewing group mechanism won’t function properly. This compression spring is unfortunately out of...

This item is a brewing group water inlet tube which is used on various Gaggia C70/C80 brewing groups. This brewing group inlet tube is made from a copper tube which has been bend and flared at the ends. You do need to use this copper tube in combination with a nut. This item has limited availability.