Gaggia italia tiiviste ja välilevysarja

Gaggia piston gasket

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

Gaggia steel ballReturn to the Gaggia Italia group overview

Gaggia short cammeReturn to the Gaggia Italia lever group parts overview

Gaggia piston boltReturn to the Gaggia Italia group overview

The item on this page is a Gaggia lever group piston shaft. This item is made up out of a gear rack and the bottom coupler. This coupler can be easily disconnected from the piston shaft itself. This coupler can be attached to the stainless steel piston. This item is unfortunately out of production and not available anymore.

Safety valve 1/2"1,8 Certif CE PED IV