Gaggia portafilter -lisäosa

Gaggia filterholder springReturn to the Gaggia Italia lever group parts overview

Gaggia ryhmäsuihku dia 49mm

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

The product on this page is a stainless steel piston for the Gaggia America and Gaggia Italia lever brewing groups. This piston has been made from 1 piece of stainless steel. The outer diameter of the piston is 50mm and the length is 82mm. The piston has the one way valve already installed. The piston also comes with a stainless steel shower screen with a...

Gaggia big cammeReturn to the Gaggia Italia lever group parts overview

The item on this page is a Gaggia lever group piston shaft. This item is made up out of a gear rack and the bottom coupler. This coupler can be easily disconnected from the piston shaft itself. This coupler can be attached to the stainless steel piston. This item is unfortunately out of production and not available anymore.

The single filterbasket on this page can be used on a variety of Gaggia espresso machines. This filter basket is manufactured by the Italian company IMS filtri with the reference of GA1T182. This 1 coffee filterbasket can hold about 7 grams of ground coffee. The outer diameter of this filter basket is 68mm and the height is 24,5mm. The hole pattern is in...

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...