Gaggia italia tiiviste ja välilevysarja

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

Tällä tuotesivulla löydät portafilter-kaasun, joka sopii erilaisiin antiikkisiin Faema-espressokoneisiin. Faema Marte, Faema Mercurio, Faema E61 Tämä portafilter-kaasun halkaisija on 72,5 mm sisäinen halkaisijaltaan 57 mm ja paksuus 8 mm. Tuote on valmistettu NBR:stä. Kuten aiemmin mainittiin, voit käyttää tätä erilaisissa Faema-malleissa, kuten...

Safety valve 1/2"1,8 Certif CE PED IV

This cam guide is vital in the lever mechanism used on the old Gaggia lever brewing groups. This cam guide is installed inside the side of the brewing group. The  lever cams do slide over this shaft. This item is not in production anymore.

The item on this page is a Gaggia lever group piston shaft. This item is made up out of a gear rack and the bottom coupler. This coupler can be easily disconnected from the piston shaft itself. This coupler can be attached to the stainless steel piston. This item is unfortunately out of production and not available anymore.

Gaggia portafilter supplement

This compression spring is vital in the lever mechanism used on the old Gaggia lever brewing groups. This spring is installed inside the side of the brewing group, with a small ball bearing on top of it. If this item is missing in your brewing group your brewing group mechanism won’t function properly. This compression spring is unfortunately out of...

The bearing is essential on a lever espresso machine brewing group. Otherwise it is not possible to transfer the lever movement in a vertical movement. In the brewing group of the Gaggia lever groups the bearings are embedded inside the group. On each side you will find one bearing where the pinion gear can ride on.