Gaggia C70 C80 männän tiiviste

This rubber o ring is used on the Gaggia brewing groups C70/C80 and is used on the flange side of the brewing group. This o ring is made from EPDM and has a cord diameter of 1,78mm and a internal diameter of 25,12mm. This o ring is made in Italy.

Vipun panimoryhmä käyttää hieman eri osia, sitten normaali pumpun ajama espressokone. Tämä on sama juttu käytettyjen suihkujen kohdalla. Tämä italialaisen IMS Filtri -yhtiön tekemä suihkuruutu on tästä esimerkki. Tämä suihkunäytös kietoutuu panimoryhmän hihnan ympäri pitääkseen sen paikoillaan. Tämän suihkunäytön ulompi halkaisija on 57 mm Tämä suihku on...

The item on this page is a Gaggia lever brewing group spring guide, this item can be found on the Gaggia C70/C80 brewing groups. The spring guide, keeps the main compression spring centred, has been made from pressed copper. Limited stock available

Safety valve 1/2"1,8 Certif CE PED IV

This cam guide is vital in the lever mechanism used on the old Gaggia lever brewing groups. This cam guide is installed inside the side of the brewing group. The  lever cams do slide over this shaft. This item is not in production anymore.

Gaggia steel ballReturn to the Gaggia Italia group overview

This item is a brewing group water inlet tube which is used on various Gaggia C70/C80 brewing groups. This brewing group inlet tube is made from a copper tube which has been bend and flared at the ends. You do need to use this copper tube in combination with a nut. This item has limited availability.

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...