Gaggia-ryhmän lukitustiiviste

Safety valve 1/2"1,8 Certif CE PED IV

The bearing is essential on a lever espresso machine brewing group. Otherwise it is not possible to transfer the lever movement in a vertical movement. In the brewing group of the Gaggia lever groups the bearings are embedded inside the group. On each side you will find one bearing where the pinion gear can ride on.

Tällä tuotesivulla löydät portafilter-kaasun, joka sopii erilaisiin antiikkisiin Faema-espressokoneisiin. Faema Marte, Faema Mercurio, Faema E61 Tämä portafilter-kaasun halkaisija on 72,5 mm sisäinen halkaisijaltaan 57 mm ja paksuus 8 mm. Tuote on valmistettu NBR:stä.Kuten aiemmin mainittiin, voit käyttää tätä erilaisissa Faema-malleissa, kuten...

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

This compression spring is vital in the lever mechanism used on the old Gaggia lever brewing groups. This spring is installed inside the side of the brewing group, with a small ball bearing on top of it. If this item is missing in your brewing group your brewing group mechanism won’t function properly. This compression spring is unfortunately out of...

Gaggia piston gasket

Gaggia short cammeReturn to the Gaggia Italia lever group parts overview