Gaggia-ryhmän lukitustiiviste

Tällä tuotesivulla löydät portafilter-kaasun, joka sopii erilaisiin antiikkisiin Faema-espressokoneisiin. Faema Marte, Faema Mercurio, Faema E61 Tämä portafilter-kaasun halkaisija on 72,5 mm sisäinen halkaisijaltaan 57 mm ja paksuus 8 mm. Tuote on valmistettu NBR:stä. Kuten aiemmin mainittiin, voit käyttää tätä erilaisissa Faema-malleissa, kuten...

This item is the nut installed on the top of the piston shaft on various Gaggia lever espresso machines. With this you can fixate the bottom nut. This item is unfortunately out of production and won’t be made anymore.

This flat rubber gasket is used on a variety on Gaggia lever brewing groups. This flat gasket is used to seal of the regulator rod on the back of the brewing group. This gasket itself is made from NBR and is made in the Czech Republic.

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

Gaggia filterholder gasket 73,5x57,5x8,5mmReturn to the Gaggia Italia lever group parts overview

Gaggia short cammeReturn to the Gaggia Italia lever group parts overview

Gaggia ryhmäsuihku dia 49mm

Gaggia steel ballReturn to the Gaggia Italia group overview