Faema Zodiac spring guide bushing

On this page you will find a brass gasket holder bushing for the Faema Zodiac brewing group. This bushing transfers the pressure from the outer flow regulator spring to the flat gasket in the back of the brewing group. This ring is made from brass and has an outer diameter of 14,60mm. The inner diameter is 10,00mm. the thickness is 3mm.

Faema retention valve body Return to the Faema Zodiac lever parts overview

Basically, every lever espresso machine brewing group has a piston shaft and a lever fork, might look different but the idea is the same. These 2 items need to be connected to each other, so that the force can be transferred. That’s why you have a piston shaft pin. This pin is knurled on 1 side. When you install the pin, this knurling will tighten itself...

Is the lever fork on your Faema Lever group worm out, this is the solution for it. When you have a aluminium lever fork or brass one where there is slack on the lever pint, it is time to replace it. The item on this page is a brass casted and chrome plated lever fork for the Faema lever brewing groups, of course not for all models. You can use this model...

A common problem with the aluminium Faema Zodiac lever brewing group casting is that over time the back of the aluminium group can snap off. Repairing this is normally quite a difficult challenge. This casting has been used on a variety of espresso machine models made by Faema. Like the Faema President and the Faema Lambro. Seen the parts for the Zodiac...

Faema brass cap Return to the Faema Zodiac lever parts overview

Faema ring  Return to the Faema Zodiac lever parts overview

On this page you will find a piston gasket suitable for multiple espresso machine models. You can find this piston gasket on Rancilio and Faema Lever brewing groups. The outer diameter of this piston gasket is 50mm, the inner diameter is 38mm and the thickness of the gasket is 7,5mm. On Rancilio espresso machines you can use them on the Rancilio Z9,...