Gaggia America sight glass gasket

Dette er en mutter som er montert på toppen av pistonakselen på ulike Gaggia lever espresso maskinar. Med denne kan du fikse bunnen. Dette er dessverre ikkje lenger i produksjon.

Denne cam-guiden er livsviktig i spakmekanismen som vert brukt på dei gamle Gaggia-spakbryggarane. Denne cam guide er installert inne i sida av bryggegruppen. Den  hovudbeina glipp over dette skaftet. Dette er ikkje lenger i produksjon.

The single filterbasket on this page can be used on a variety of Gaggia espresso machines. This filter basket is manufactured by the Italian company IMS filtri with the reference of GA1T182. This 1 coffee filterbasket can hold about 7 grams of ground coffee. The outer diameter of this filter basket is 68mm and the height is 24,5mm. The hole pattern is in...

The product on this page is a stainless steel piston for the Gaggia America and Gaggia Italia lever brewing groups. This piston has been made from 1 piece of stainless steel. The outer diameter of the piston is 50mm and the length is 82mm. The piston has the one way valve already installed. The piston also comes with a stainless steel shower screen with a...

It is quite common that the pinion gear on the Gaggia lever brewing group needs to be replaced. This can be from various reasons, like breaking or damaging teeth. This pinion gear is used to lower and raise the piston shaft in the brewing group. The shaft itself is installed in between 2 sealed bearings. Note: these shafts are made from steel so they can...

The filterbasket shown on this product page is a 2 coffee filterbasket suitable solely for a variety of Gaggia espresso machines. Domestic and commercial espresso models. This filter basket has been made by the Italian company IMS Filtri. The part reference for this basket from IMS is GA2T183. Note: this is not a competition basket. This stainless-steel...

Denne kompresjonsfjära er viktig i spakmekanismen som vert brukt på gamle Gaggia-spakbrygger. Denne våren er montert inne på sida av bryggegruppen, med ein liten balllager på toppen. Dersom dette elementet manglar i bryggegruppa, vil ikkje mekanismen for bryggegruppa fungere som det skal. Denne kompresjonsfjelen er uheldigvis ute av produksjon.

The item on this page is a Gaggia lever group piston shaft. This item is made up out of a gear rack and the bottom coupler. This coupler can be easily disconnected from the piston shaft itself. This coupler can be attached to the stainless steel piston. This item is unfortunately out of production and not available anymore.