Faema pákový kloubový průvodce vpravo

On each side of the aluminium casting used on the Faema Lambro, Faema President and the Faema Urania you will a pressed bracket. These brackets guide the bearings over the flattened-out surface on this bracket. The article listed on this page is for the right side of the group. To be sure that you order the correct side. The rounded where the rounded off edge is deeper needs to be oriented to the back side of the brewing group.

It is quite common that these brackets wear out, break or just rust. Seen they are made from steal with a zinc coating.

You can just easily install them. Remove the 2 bolts from the side of the group. Remove the bracket and do the same thing vice versa. This procedure can not(or can be difficult) be done while the group is completely assembled.

If you are not sure if this bracket is suitable for your Faema zodiac or any other Faema lever group, just send us a message and we might be able to help.