Měděná trubka 12x1mm

Na této stránce produktu najdete mosaznou svařovací čepici. Tyto svařovací čepice se prodávají na koncích měděných trubek v kombinaci s svařovacím oříškem. Tento kulatý povrch těsnění off, když matice to utáhne. Mosazný materiál obklady a tyto těsnění mimo ventil. V určitém okamžiku bude tato těsnění úniku.Jedná se o největší velikost svařovacího kování,...

Mosazná matice 1/2" BSP-G pro 14mm svařovací čepiciVráceníČeštinazobrazit stránku

The nut on this product page is a weld-end cap nut. This nut is used to install the pipe with the welded end cap on another fitting. This brass nut is used in combination with a welding accessory. The thread inside is a 3/8” BSP-G female thread. The height of the nut is 16mm and the center hole of this nut is 12.5mm. This brass weld nut can be used in...

A welding end cap nut is used to put pressure on the welding cap so it seals against the conical surface of it. Once there is not enough pressure from the back from the welding cap nut, the seal won’t work. This type of welding end cap is slightly different then the standard types of caps. You will see this type of fitting for instance on the water...

A welding end cap nut is used to put pressure on the welding cap so it seals against the conical surface of it. Once there is not enough pressure from the back from the welding cap nut, the seal won’t work. This type of welding end cap is slightly different then the standard types of caps. To start, this welding end cap is a male thread instead of a...